Replacing or removing the S3400-H circuit card hold-down bracket

The circuit card hold-down bracket must be removed when replacing the S3400-H internal system components including cables, circuit cards, and the memory module.

The circuit card hold-down bracket might use pushbutton fasteners or levers to secure the bracket to the chassis. Follow the steps for the type of circuit card hold-down bracket that is installed in your system:

• Removing a circuit card hold-down bracket
• Replacing a circuit card hold-down bracket

Removing the circuit card hold-down bracket

To remove the circuit card hold-down bracket:

1. Shut down the system and unplug the AC power cords.
2. Remove the front bezel and top cover.
3. Remove the circuit card hold-down bracket as follows:
   • Pushbutton type: See figure Removing and replacing the circuit card hold-down bracket.
     1. Pull up on the pushbutton fasteners that connect the hold-down bracket to the inside rail.
     2. Remove the bracket.
   • Lever type: See figure Removing and replacing the circuit card hold-down bracket.
     1. Pull up on the pushbutton fasteners that connect the hold-down bracket to the inside rail.
     2. Remove the bracket.
4. Continue with any internal component replacement procedures, such as:

• Circuit cards
• Drive cables
• Memory module

Replacing the circuit card hold-down bracket

Follow the steps for the type of circuit card hold-down bracket that is installed in your system:

• Replacing a pushbutton-type circuit card hold-down bracket
• Replacing a lever-type circuit card hold-down bracket

Replacing a pushbutton-type circuit card hold-down bracket

To replace a pushbutton-type circuit card hold-down bracket:

1. Pull up on the pushbutton fasteners to make sure that they are fully extended. See Removing and replacing a pushbutton-type circuit card hold-down bracket.
2. Position the bracket toward the front of the chassis, so that the first pushbutton fastener is aligned over the 4th hole back on the inside rail.
3. Hook the tab on the hold-down bracket over the outer rail inside the chassis.
4. Adjust the bracket position so that:
   • the pad on the hold-down spacer is over the tallest card, and
   • the holes in the central rail line up under the pushbutton fasteners.
5. Push down on the entire bracket. If the fasteners are correctly aligned, it will snap into place.
6. Push down on each of the pushbutton fasteners to lock the bracket in place.
7. Replace the top cover and front bezel.
8. Restore power to the system.

Replacing a lever-type circuit card hold-down bracket

To replace a lever-type circuit card hold-down bracket:

1. Make sure the levers on the hold-down bracket are up. See Removing and replacing a lever-type circuit card hold-down bracket.
2. Position the bracket so that the pad is over the circuit cards.
3. Seat the bracket on the lower part of the outside and inside rails of the chassis.
4. Press down on the levers firmly to clamp the bracket against the chassis rails.
5. Replace the top cover and front bezel.
6. Restore power to the system.

Top of page