DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC

DEFINITY Made Easy Tools
Issue 3, December 2001



Install and Connect Single-Carrier Cabinets

Install Rear Panels

Return to Task List

  1. Install the rear panels and loosely thread each screw. See Rear Panel Screw Locations.

  2. For unstacked cabinets, tighten the screws securely.

    3. For a stack of cabinets, allow the screws labeled callout 4 to remain loose. These screws are tightened when the ground plates are installed.

  3. Be sure the Time Division Multiplexing (TDM) bus cables and the Inter-Cabinet Cables (ICC) are not pinched by the panels. Also be sure the cables are routed through the channels provided on the rear panels.

Rear Panel Screw Locations

Figure Notes:
      1. Cabinet in A Position (No Ground Plate is Installed on an Unstacked Cabinet)

      2. Rear Ground Plate (Attached Between Stacked Cabinets)

      3. Cabinet in B Position

      4. Screws to Loosen

Return to Task List

DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC
Copyright� 2001 Avaya Inc.
Send comments to MadeEasy Development Team



Always check at the Made Easy Web site for the most current information.