Removing the drive cage

You must remove the drive cage to:

• Replace the DVD drive (any message server)
• Replace an IDE RAID drive in the Message Storage Server standard configuration (MSS-S)
• Replace the IDE drive in the Messaging Application Server (MAS)

To remove the drive cage:

1. Shut down the system and unplug the AC power cords.
2. Remove the front bezel and top cover.
3. Disconnect the signal and power cables to all drives in the cage assembly.
• MSS-S: See MSS-S drive cage cabling.
  1. Unplug the power connectors from the DVD, upper drive, and lower drive.
  2. Unplug the 80-pin IDE ribbon cable from the DVD and upper drive (hdc).
  3. Unplug the 80-pin IDE ribbon cable from the lower drive (hda).
• MSS-H: See MSS-H drive cage cabling.
  1. Unplug the power connector for the DVD, and the two power connectors for the SCSI RAID backplane.
  2. Unplug the J6 (3-pin) and J7 (10-pin) jumper cables from the SCSI RAID backplane.
  3. Unplug the 80-pin IDE ribbon cable from the DVD drive.
  4. Unplug the SCSI ribbon cable from the SCSI RAID backplane.
• MAS: See MAS drive cage cabling.
  1. Unplug the power connectors from the DVD player and lower drive (hda).
  2. Unplug the 80-pin IDE ribbon cable from the DVD and the lower drive.
4. Remove the drive cage retaining screws. See Removing or replacing the drive cage.
   1. Remove the 4 screws from the front of the drive cage.
   2. Remove the 2 flathead screws from the side of the chassis, located about 6 inches from the front of the cage.
5. Gently slide the drive cage assembly forward and out of the unit.
6. Place the drive cage assembly on a clean, static-free surface.
7. Replace the appropriate drive:
   • DVD drive
   • IDE RAID drive
   • IDE drive

    

Top of page