When you upgrade to a new system release, you must upgrade the system software; typically you must upgrade WinSPM as well. For more information, see System Programming.
Unless the system is being backed up or restored, a remote system programming connection takes priority over a local user. If the local user is programming when a remote user connects to the system, the system sends a warning message to the local user and disconnects that user.
The PC used for system programming connects to the lower RS-232 jack on the processor module in the control unit. This connection runs at 1.2 or 2.4 kbps with autobaud switching.
You can print system programming reports and/or save them on the PC's hard or floppy disk drive. At the same time, the report is displayed on the screen together with prompts for browsing.
You should not print system programming reports when the system is handling more than 100 calls per hour.
You can use a printer connected to the system programming PC to print system reports. Alternatively, you can send reports to a printer connected to the SMDR port on the control unit [for more information about SMDR, see Station Message Detail Recording (SMDR)]. SMDR information may be lost, however, while system programming reports are being printed through the SMDR port.
 |
ISDN Terminal Adapter |
